Points Related With Parts of Sawdust Pellet Mill

You should notice some points when running the sawdust pellet mill. Screen meshes are made of sheet steel or iron punching. If screen meshes are partly worn out or hit by foreign matters, you can repair them with rivets or tins. While, if worn-out area is large, you should change the damaged meshes with new ones.

When installing the screen meshes, you should make the mesh and shoe closely contact with each other. To avoid raw materials from being get stuck at connecting place, you should carefully notice the above points. Among all the parts of saw dust pellet machine, crushing claw and hammer plates are easy-wearing parts.

Meanwhile, they are also the key parts that can influence the output and quality of biomass pellets. If the above parts are seriously worn out, you should change them immediately. When changing the worn-out claws, you should firstly pull out the disk. Before pulling out it, you should dismantle the lock plates of round nut, then dismantle the round nit with hook wretch and finally pull out the disk with specialized syraz.

To keep the balance of working rotors, you should change them in sets. To ensure the steady work of sawdust pellet mill, you should do the static balance test after changing the rotors. You should not forget to install the spring washer. As to the teeth, they should be qualified. Greater discounts for you on website!